• Non-Contact Measurement
• Surface Finish and Contour Measurement
• Form and Roundness Measurement
• CMMs
• Air Gauging and Multi-Gauging
• Special Gauging Systems
• Length and Height Gauges
• Microscopes and Borescopes
• Autocollimators and Interferometers
• Hardness Measurement
• Gear Measurement
• Force and Torque Measurement
• Stroboscopes and Maintenence Equipment
• Data Acquisition and SPC
• Metrology Direct Services
• Calibration Services

 

Etamic Digitamic

Digital Probe Display Unit

The Digitamic is a combined digital and dial display for use with one or two LVDT probes. It is designed to perform very accurate measurements. The Digitamic is low cost, simple, easy to integrate and user friendly. The modular aspect of the Digitamic simplifies the connection and data exchange between units and/or external networks.

Features

• Shopfloor measurement
  
• Suited to harsh environments
  
• High sensitivity
  
• Large choice of probes
  
• Easy to install
  
• Static or dynamic measurements
  

The Digitamic is fully programmable using three data entry keys as follows:

Display – providing the following information

• Actual dimension or difference from an adjustable zero
  
• Metric or inch settings
  
• Dimension status i.e. within specification, oversize or undersize
  
• Reversible display

Measurement

• Simple or differential
  
• Dynamic Gauging with “hold” feature:
  Max., Min., T.I.R., (Max.+Min.)/2
  
• Upper and lower tolerance limits
  
• Zero offset
  
• Compensation for surface finish
  
• Measurement result memorised with auto reset on each gauging cycle
  

Mastering (two options)

• Single master set within specification limits
• Max/min masters. The Digitamic computes the gain automatically based on certified values of the masters